Rotary valves type JK-S/JK-EXS

Schleuse Typ JK S JK EXS Skizze 01
Dimensional specifications are given in the table below.

Rotary valves type JK-S/JK-EXS are fitted with a 6-bladed rotor with hard-wearing rubber blades bolted to the rotor shaft plate profiles.

The rotor is separated from the rotor housing by felt ring. The shaft is suspended on bearings and connected directly to the gear motor. Type JK-200S is also fitted with a safety coupling between rotor and gear motor.

The rotor is made of 2 mm plate and painted with industrial primer.
There are two versions:

1. Rotor fitted with neoprene rubber blades for max. temp. 70°C and min. temp. -10°C.
2. Rotor fitted with silicone rubber blades for max. temp. 250°C and min. temp. 60°C.

Rotation sensor
Supplied as standard ready for fitting of rotation sensor.

JK-S rotary valve is ATEX-approved for category 2D. JK-EXS is approved for category 1D safety system, see page 52 ref. EXS control system.

Diagram states loss through rotary valve depending on pressure conditions.
Diagram states loss through rotary valve depending on pressure conditions.
Rotation sensor
Rotation sensor
Rotary valve type JK S JK EXS tabelle 01
Rotor diameter = ø300 mm
Rotary valve type JK S JK EXS tabelle 02